¿Hablamos?
Gateway AS-i a DeviceNet Pepperl+Fuchs VBG-DN-K20-DMD
Pepperl+Fuchs

Gateway AS-i a DeviceNet Pepperl+Fuchs VBG-DN-K20-DMD

SKU: PEPPER-VBG-DN-K20-DMD

Gateway AS-i a DeviceNet Pepperl+Fuchs modelo VBG-DN-K20-DMD.

$49,258.35
Sin stock
1
Solicitar cotización

Descripción técnica

**Gateway AS-i a DeviceNet Pepperl+Fuchs VBG-DN-K20-DMD** Gateway AS-i a DeviceNet Pepperl+Fuchs modelo VBG-DN-K20-DMD. ### Descripción del fabricante DeviceNet Gateway **Entrega estimada:** 10 a 15 días hábiles (bajo pedido). Fuente: [Pepperl+Fuchs (sitio oficial)](https://www.pepperl-fuchs.com/en/products-gp25581/33314)

Categoría: Sensores y detección

Especificaciones

Especificaciones técnicas
General
AS-Interface specificationV3.0
PLC-Functionalityactivateable
Duplicate address detectionfrom AS-Interface slaves
Earth fault detectionintegrated
EMC monitoringintegrated
Diagnostics functionExtended function via display
UL File NumberE223772 only from low voltage, limited energy source (SELV or PELV) or listed Class 2 source
DisplayIlluminated graphical LC display for addressing and error messages
LED AS-i ACTIVEAS-Interface operation normal
LED CONFIG ERRconfiguration error
LED PRG ENABLEautom. programming
LED POWERvoltage ON
LED PRJ MODEprojecting mode active
LED U AS-iAS-Interface voltage
LED MNSModule/net status
Switch SETSelection and setting of a slave address
OK buttonMode selection traditional-graphical/confirmation
Button MODEMode selection PRJ-operation/save configuration/cursor
ESC buttonMode selection traditional-graphical/cancel
Insulation voltage≥ 500 V
Rated operating voltagefrom AS-Interface
Rated operating current≤ 200 mA from AS-Interface
ProtocolDeviceNet
Interface typeRS 232, serial Diagnostic Interface
Transfer rate19,2 kBit/s
AS-Interfacespring terminals, removable
DeviceNet5-pin CombiCon connector according to DeviceNet specification
Directive 2014/30/EU EN 62026-2:2013EN 62026-2:2013
Directive 2014/30/EUEN 62026-2:2013
Electromagnetic compatibilityEN 61000-6-2:2005, EN 61000-6-4:2001, EN 50295:1999
Grado de protecciónEN 60529:2000
Shock resistanceEN 61131-2
Aprobación ULAn isolated source with a secondary open circuit voltage of ≤ 30 V DC with a 3 A maximum over current protection. Over current protection is not required when a Class 2 source is employed. UL mark does not provide UL certification for any functional safety rating or aspects of the device.
Temperatura ambiente0 ... 55 °C (32 ... 131 °F)
Storage temperature-25 ... 85 °C (-13 ... 185 °F)
Mass520 g
Height 120 mm Width 85 mm Length 76 mm76 mm
Alto120 mm
Ancho85 mm
Largo76 mm

Productos relacionados